Lowering the Mast on a Flicka 20
It’s time to do some work on the Sampaguita, starting with the mast. I had the mast down in 2014 for some minor work, but there will be a bit more going on this time around. The last time I lowered it, I had to ask for some help when it was about halfway down. This time I was able to do it by myself thanks to Bruce Bingham’s, The Sailor’s Sketchbook. While I do not own the book, a dock mate, Bruce (irony?) does. He was gracious enough to let me examine the procedure for lowering a mast (and take photos.)
I discovered the simple part of the procedure which I was missing the last time. I needed to purchase two Stainless-Steel rings for $1.74 and seize them to the shrouds at the tabernacle level. The rest was line work. I still had the wooden crutches from the previous lowering to hold the mast once it was down. I used old fenders as cushions, and I had to finesse “the landing” to avoid crushing the solar vent and the forward hatch.
The procedure is mostly prep and cleanup. It took a few hours to get everything ready. Then, about three minutes for the actual lowering. Finally, two or three hours of disassembling lines and wires and tidying up.
A was hoping to get a video, but it did not work out. Bruce offered to spot me while I did the procedure. I was keen on doing it alone if I could. He also worked crowd control. If you’ve ever done work at the dock before, you know that curious, good-natured, and well-intentioned neighbors will come around and start asking questions at the most inopportune times. Bruce handled this well so I could ignore them and focus on the task. In order to get a video, I would have needed a third person. “Three’s a crowd,” and I wanted to avoid crowds.
The photos above show how I rigged the lines for bringing down the mast. I used the boom as a gin pole, and the mast pivoted forward on the tabernacle.
The crutches and fenders used to finesse the soft landing are pictured below. The mast itself only weighs about 50 lbs, with maybe another 10-20 pounds of rigging aloft. I connected the jib halyard to the topping lift. The lift ran from a block at the far end of the bowsprit to the cockpit where I was controlling the maneuver. I pulled the mast forward using those lines until gravity could take over. Then I used the main sheet to control the lowering. This sheet is usually a four-part block and tackle, but since the mast is light enough, I took it down to two-parts as I needed the extra line for the full descent.
I considered writing an article on how to lower the mast but realized it would be like re-inventing the wheel. If you intend to lower a mast yourself, find a copy of Bruce Bingham’s, The Sailors Sketchbook. It gives clear step by step instructions and amazing sketches to support them. I don’t think I could do a better job. It is out of print, but you can still find copies of it on the internet or maybe your local used book store. See if you can buy it someplace other than Amazon. Or find a neighbor who has it like I did. Use the computer you carry around in your pocket to take the pictures of the five pages you need. If you contact me, I will email them to you. I don’t feel comfortable publishing them here without Bruce’s permission.
For the newbie, Bruce Bingham is also the designer of the Flicka 20, though he doesn’t use the Flicka in the sketches. I have never met Bruce, but his design has had a major influence on my life over the past six years. Thank you Bruce.